Call Toll-Free in US
(866) 418-1840
(Mon-Fri) 8:30 am - 5 pm PST
(Sat) 9 am - Noon PST

IMMEDIATELY PURGE YOUR CIRCULATION PUMP AIR LOCK TO AVOID DAMAGING THE MOTOR

It’s common to have a circulation pump airlock after re-filling your spa. An airlock should be addressed immediately because it won’t take much time for the motor to overheat and burn out, even a new one. Without bubbles shooting out from the foot well, there will also be a “flow error” message on the upper control panel and the heater will not turn on.

  • 1. Air bubbles should be shooting out of the ozone/heater port in the footwell, about 18”. If not...

  • 2. Remove the air bleeder valves near the filters. There should be a constant stream of bubbles from the ozone bleeder valve port. If not...

  • 3. Turn off power at the GFCI

  • 4. Remove the ozone filter from its canister.

  • 5. Put a garden hose over the ozone bleeder port and force water into the opening. With any luck, air bubbles will be forced through the plumbing and come out the footwell of the spa.

  • 6. Turn on the GFCI. The circulation pump should run, bubbles should shoot out of the footwell, and the upper control display should read normally.

  • 7. If not... turn off the power again at the GFCI.

  • 8. Hold the running hose over the ozone port in the footwell and watch for bubbles to come through the port by the filter. You may have to repeat this top and bottom routine up to 3 times to purge all the air from the circulation pump plumbing.

  • 9. Turn on power at the GFCI to see if the error message is gone and the bubbles are flowing again.

  • 10. When the circulation pump is operating normally, replace the bleeder valves, filters, and filter covers.

These instructions are also on-line in color at
www.easyspaparts.com
Should you require additional information,
please call us toll free at 866.418.1840.

These instructions are for informational purposes only. Easy Spa Parts does not guarantee that following these instructions will resolve your specifi c spa condition, nor does Easy Spa Parts accept liability for work performed by anyone attempting the repair or part replacement. These instructions are provided solely by Easy Spa Parts. Certain parts mentioned in the instructions are manufactured by third parties, including Dimension One Spas. Dimension One Spas has not supplied or reviewed these instructions. Dimension One Spas shall have no liability to you relating in any manner to these instructions or any acts or omissions by Easy Spa Parts.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW: 1) EASY SPA PARTS AND DIMENSION ONE SPAS EXCLUDE ALL IMPLIED WARRANTIES THAT MAY ARISE IN CONNECTION WITH THE INSTRUCTIONS, INCLUDING ANY WARRANTY OF MERCHANTABILITY, NON-INFRINGEMENT, AND FITNESS FOR A PARTICULAR PURPOSE; 2) NEITHER EASY SPA PARTS NOR DIMENSION ONE SPAS SHALL BE LIABLE UNDER ANY LEGAL OR EQUITABLE THEORY, WHETHER IN CONTRACT, TORT OR OTHERWISE (INCLUDING NEGLIGENCE AND STRICT LIABILITY) FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, SPECIAL OR PUNITIVE DAMAGES WHATSOEVER , ARISING FROM YOUR USE OF THE INSTRUCTIONS OR FROM ANY MATERIAL CONTAINED IN, OR OMITTED FROM, THE INSTRUCTIONS