For spas manufactured in 2003 and before, follow steps one and two; for Dimension One Spas manufactured from 2004 to present and have two filters, follow steps one through nine.

Step 1:

On a monthly basis, remove the filters, (use the "Stand By Mode" on your spa if you have it), and rinse with water. We recommend the Filter Flosser (Easy Spa Parts items # 01561-FF) pictured here, because it is shaped like a filter with small holes that flush water between the pleats. This makes cleaning easier and more efficient.

Step 2:

Every second month, use a filter cleaner in addition to water. This helps loosen oils, lotions, minerals and other debris that water alone cannot remove. We recommend Clean & Perfect all purpose cleaner, a natural enzyme product that is very effective. Rinse the filter, apply a filter cleaner, let stand 15 minutes, and rinse again until all the bubbles are gone. If your spa was made before 2004, replace the filters, and turn off the “stand by mode” if you have one. If your spa has two filters and was made from 2004 on, proceed through the following steps.

Step 3:

Press the first "Jet" or "Pump" button on the upper control panel. Set the pump on high speed and watch for a large volume of water to flow through one of the filters. This filter is where the basket assembly should be placed.

Step 4:

The second filter usually has a vented cap positioned over it. (The Vision Sanitizing Cartridge is placed here). With the filter already removed, look for and remove the filter screen at the bottom of the canister.

Step 5:

Using a small, flat head screwdriver, place your forefinger towards the end of screwdriver as pictured. Slowly move the screwdriver to the bottom of the filter screen until you reach either of the tabs as shown here. Place the screwdriver head between the base of the screen and the inside of the tab; turn it slowly to open the tab slightly so you can tilt the screen and move it away from the tab. If the filter screen does not lift away from the bottom of the canister easily, move the screwdriver to the opposite side and try again.

Step 6:

Remove the mesh screen nested inside the larger filter screen.

Step 7:

Rinse the mesh screen clean with a garden hose.

Step 8:

Reinstall the mesh screen inside the filter screen as pictured. Both pieces are slotted for a perfect fit.

Step 9:

Replace the filter screen. The 2 tabs on the filter screen mate with the "ears" on the bottom of the canister. Attach one side, then the other.

Replace the filter and vented cap. Turn off "Stand By Mode" and your filter maintenance is complete.

These instructions are also on-line and
in color at www.EasySpaParts.com
Should you require additional information,
please call us toll free at 866.418.1814

These instructions are for informational purposes only. Easy Spa Parts does not guarantee that following these instructions will resolve your specific spa condition, nor does Easy Spa Parts accept liability for work performed by anyone attempting the repair or part replacement. These instructions are provided solely by Easy Spa Parts. Certain parts mentioned in the instructions are manufactured by third parties, including Dimension One Spas. Dimension One Spas has not supplied or reviewed these instructions. Dimension One Spas shall have no liability to you relating in any manner to these instructions or any acts or omissions by Easy Spa Parts.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW: 1) EASY SPA PARTS AND DIMENSION ONE SPAS EXCLUDE ALL IMPLIED WARRANTIES THAT MAY ARISE IN CONNECTION WITH THE INSTRUCTIONS, INCLUDING ANY WARRANTY OF MERCHANTABILITY, NONINFRINGEMENT, AND FITNESS FOR A PARTICULAR PURPOSE; 2) NEITHER EASY SPA PARTS NOR DIMENSION ONE SPAS SHALL BE LIABLE UNDER ANY LEGAL OR EQUITABLE THEORY, WHETHER IN CONTRACT, TORT OR OTHERWISE (INCLUDING NEGLIGENCE AND STRICT LIABILITY) FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, SPECIAL OR PUNITIVE DAMAGES WHATSOEVER, ARISING FROM YOUR USE OF THE INSTRUCTIONS OR FROM ANY MATERIAL CONTAINED IN, OR OMITTED FROM, THE INSTRUCTIONS